All, I have tried contacting Edelbrock but no luck yet.
Fitting instructions say "Apply a continuous 1/8" bead of RTV sealer to end sealing surfaces on block and ....." Does that mean around the periphery of each cylinder row of four cylinders?
Fitting Edelbrock alloy heads
Fitting Edelbrock alloy heads
Per
Not only English cars these days, an Italian is part of the stable again
Not only English cars these days, an Italian is part of the stable again
Re: Fitting Edelbrock alloy heads
Reply from Edelbrock just came in. It is the wall between cylinder rows, one in fron and one at the rear.
Per
Not only English cars these days, an Italian is part of the stable again
Not only English cars these days, an Italian is part of the stable again
Re: Fitting Edelbrock alloy heads
Hi Per,
do they mean the 10mm wide zone where block/head gasket/head/intake and valley pan/are meeting?
That’s a typical RTV application zone. In the attached mock-up the valley pan is still missing
Engine is now running leak proof.
Rgds
Thomas
do they mean the 10mm wide zone where block/head gasket/head/intake and valley pan/are meeting?
That’s a typical RTV application zone. In the attached mock-up the valley pan is still missing
Engine is now running leak proof.
Rgds
Thomas
- Attachments
-
- F066DBCD-4210-428C-9D14-9B2159C369A5.jpeg (113.33 KiB) Viewed 2123 times
Int Mk III
2211-1490
2211-1490
Re: Fitting Edelbrock alloy heads
Yes that is the area.
Per
Not only English cars these days, an Italian is part of the stable again
Not only English cars these days, an Italian is part of the stable again
Re: Fitting Edelbrock alloy heads
Double posting
Last edited by Per on Tue Apr 05, 2022 6:14 pm, edited 1 time in total.
Per
Not only English cars these days, an Italian is part of the stable again
Not only English cars these days, an Italian is part of the stable again
Re: Fitting Edelbrock alloy heads
Hi Roh,
Yes - these are 440source stealth heads. You may see the logo if you zoom into the picture and check the runner to cyl 7 inlet valve.
Rgds
Thomas
Int Mk III
2211-1490
2211-1490
Re: Fitting Edelbrock alloy heads
The RTV is applied AFTER head to block installation during intake/valley pan installation.
Rgds
Thomas
Int Mk III
2211-1490
2211-1490