The Jensen Owners' Club

I have just done mine, they had been diamond cut and lacquered but were looking tatty. I found the lacquer came off with a sharp paint scraper very easily, I then used wet and dry paper grades from 400-1200 and finished off with a stiff buffer and brown bar. Took a couple of hours for each wheel in...

If anybody else is traveling south for this i will be out on the A2 at about 10.30 am .

Alan .

Well done Steve .

Alan

WELL DONE

Alan .

Anything on PWC 35 please

Thanks Alan .

voted .

I have noticed that every time i am out for a quick spin i am hunted down by some boy racer with a powerful car . Today was no exception , it was like a red rag to a bull , the TVR owner had to show me what his car could do , fed up with all this i hit the gas and gave her all . OK he was losing me ...

posted my vote Tony .

Good luck

Alan .

Taking my usual nap in Leman ST E1 i was woken by the familiar rumble of the V8 , there she was an Interceptor white with a black vinyl roof , very classy looking and certainly standing out from all the usual rubbish that surrounded her .

Lovely car who ever it belongs to .

Alan .

Could i ask a question in regards to electronic ignition please , by fitting this type of ignition would it allow for a greater degree of advance to be used than a points system , this is presuming all is well with the engine .

Sorry to hijack the thread .

Alan .

bobclevenger wrote:

money_one_four wrote:

bobclevenger wrote:Nope, that's one where our terms are the same.

So what is the correct name for your bumpers over there ?

Bumpers.

No sorry , you will have to change that to fenders , sounds far better and more American

I wont bother you anymore on this subject i promise

bobclevenger wrote:Nope, that's one where our terms are the same.

So what is the correct name for your bumpers over there ?

We also have another type of Trannie over here. They are usually white and in the outside lane of the motorway( freeway ) or 3 inches from your bumper ( fender) with the driver on his mobile ( cell phone). Steve Just a question as to UK vs. US usage; does not the US 'fender' translate as the UK 'wi...

When i renewed mine the kit came with no side seals just two little pipe cleaners , you fill the gaps with RTV moisten the pipe cleaners and slide them up into the RTV .

Strange but it works .

Alan .

I have fitted new mains and big end shells in my car without any problems , a little trick to help remove the upper mains shell is to cut one of the old lower shells in half , using the end without the tang and making sure no burrs are left on you can use this to push the upper shell round and down ...